Skip to Content
Petrol-powered Leaf Blower
The starter cord is broken
Try this solution
Replace the starter cord
Replace the rope with a nylon rope of the same calibre and length.
Use the correct rope type for your specific product. You can find the information in your leaf blower's operator's manual.
1
Detach the starter
Remove the bolts and lift off the starter and separate the starter from the leaf blower.
2
Detach the starter
Pull out the old starter cord completely. Attach the new starter cord. Ensure that the knot is as small as possible and enters the cut-out on the starter pulley. Wind the cord 3 turns anti-clockwise around the starter pulley.
3
Tighten the return spring
Turn the starter pulley anti-clockwise
4 revolutions. Check the spring tension. With the cord
completely pulled out the cord pulley, it should be able to be turned at least another half revolution.
4
Fit the starter handle on the cord
Thread the starter cord through the handle and support washer (A). Turn the washer so that the bevelled edge faces inwards towards the starter handle. Tie a small knot in the starter cord and pull it into the handle.
5
Fit the starter
Hold the starter in place and pull lightly the cord to make sure the starter engages in the pawl. Tighten the screws and check that the starter works.
On this page