Skip to Content
Petrol-powered Trimmer support
Why are my two-stroke grass trimmer and brushcutter not running to full throttle?
If your Husqvarna grass trimmer or brushcutter starts normally but won’t reach full speed when you pull the throttle, the problem is usually related to fuel delivery, airflow or engine maintenance.
Many full-throttle problems can be solved with a few simple checks.
Quick check
Before troubleshooting, check the following:
Is the fuel fresh and mixed correctly?
Is the air filter clean?
Is the cutting attachment free to rotate?
If everything looks normal, continue with the checks below.
Most common causes and fixes
Old or incorrect fuel (most common)
Old fuel or an incorrect fuel mixture can reduce engine performance and prevent the engine from reaching full speed.
What to do:
Empty the fuel tank
Refill with fresh fuel using the correct fuel-to-oil ratio.
Old fuel is one of the most common causes of poor acceleration.
How to mix fuel for a grass trimmer or brushcutter
Dirty air filter
A blocked air filter limits the amount of air entering the engine.
What to do:
Remove the air filter.
Clean or replace it if necessary.
A clean air filter helps maintain the correct air-fuel mixture.
Dirty spark plug
A worn or dirty spark plug may allow the engine to idle but struggle when higher power is needed.
What to do:
Inspect the spark plug
Clean or replace if necessary
Fuel filter or fuel line blockage
Restricted fuel flow prevents the engine from receiving enough fuel at higher throttle.
Check for:
Dirty fuel filter
Damaged fuel lines
Fuel restrictions
Clogged spark arrestor
A blocked spark arrestor can restrict exhaust flow, making it difficult for the engine to reach full speed.
What to do:
Remove the spark arrestor
Clean carbon deposits using a wire brush
Replace it if it is damaged or heavily clogged.
A clean spark arrestor allows exhaust gases to escape properly, helping the engine accelerate more smoothly.
What is the purpose of a spark arrestor on my grass trimmer and brushcutter?
Husqvarna recommends that the spark arrestor is cleaned after every 50 hours of use.
Cutting attachment overloaded
Using incorrect trimmer line or attempting to cut very dense vegetation can overload the engine.
Check that:
The correct line diameter is installed
The trimmer head or blade is suitable for the material you are cutting
When should you stop using the machine?
Stop using the trimmer if:
The engine bogs down repeatedly
Power continues to decrease
You hear unusual noises
The engine begins smoking
Continuing to operate the machine could lead to further damage.