Skip to Content
Snow Thrower support
How to start the engine, manual start
1
Put on ON/OFF into the ignition slot (B). Do not turn the key
2
Turn the fuel ON/OFF switch (C) to the ON position
This solution applies only for ST 424/427/430.
3
Put the throttle control (A) to the FAST position
4
Turn the ON/OFF key to the ON position.
5
If the temperature is lower than -17° C (0° F), push the primer 3 times.
CAUTION: Do not push the primer too many times. It can prevent the engine from starting. If the engine is flooded, wait for a few minutes before you try to start. Do not push the primer.
This solution applies only for ST 424/427/430.
6
Pull the starter rope handle (D).
CAUTION: Do not release the starter rope handle quickly. Move it slowly to the start position.
NOTE: If the starter rope is frozen, slowly pull out as much rope out of the starter as you can. Release the starter rope handle. If the engine does not start, do the procedure again or use the electric starter.
7
Run the engine 2-3 minutes at very low speed before you start to throw snow.
8